Tc-helicon VoiceWorks Plus Manual Manuel d'utilisateur télécharger pdf (Page 11)

777

FRONT PANEL DESCRIPTIONS

BYPASS button

Pressing BYPASS mutes all processing blocks of

VoiceWorksPlus. Any audio signal that is received at

the line or mic input is passed directly to the left and

right audio outputs.

STORE button

Pressing STORE initiates the storing sequence and

presents the preset name and target user preset

number in the main display. In Store mode, you can edit

the name of the new preset by turning the EDIT 1

knob to highlight the letter positions and then using

EDIT 2 to change the letter.You can press either EDIT

or SETUP to cancel a Store operation or press STORE

or the Data Wheel to complete.

8.The Data Wheel

The Data Wheel has two actions: you can turn it and

you can press it. When the display shows a preset

name, turning the Data Wheel allows you to browse

through the available presets. You can then press the

Data Wheel to load the preset of your choice.

If you’ve pressed the EDIT or SETUP buttons, this

wheel cycles up and down through the menus available

in these modes. Pressing it has distinct functions in

some menus.

When the STORE button is lit, turning the Data Wheel

allows you to choose a user bank preset number in

which to store your edited preset and pressing it

completes the Store operation

9. Mic Input control group

MIC GAIN knob

The MIC GAIN knob allows you to tailor

VoiceWorksPlus’s input gain to match your

combination of microphone sensitivity and singing

level.

MIC IN button

The Mic In switch controls which of VoiceWorksPlus's

inputs: Mic In or Line In, will drive the unit.This switch

must be lit before any adjustment of the MIC GAIN

and phantom power will have any effect.

48V button

You must press and hold this button for approximately

1 second to send DC voltage to condenser

microphones requiring phantom power. When using

non-phantom powered mics, leaving this off is best.

-20 dB switch

This switch reduces the sensitivity of the mic input

when you use mics that have a high output level. You

would press this switch when you notice that even

though the MIC GAIN knob is set to minimum (fully

left), the Input Clip LED shows clipping during singing.

In this case, press the -20 dB switch and you will have

more range adjustment with the Mic Gain control.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Tc-helicon VoiceWorks Plus Manual Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Tc-helicon VoiceWorks Plus Manual