Tc-helicon VoiceWorks Plus Manual Manuel d'utilisateur télécharger pdf (Page 12)

BACK PANEL DESCRIPTIONS

1. Mic Input

When the MIC IN switch on the front panel is lit, this

becomes the main analog input. It accepts a balanced

mic level XLR cable carrying a monophonic vocal

source.

2. Line Input

When the MIC IN switch is not lit, this 1/4” jack

becomes the main analog input.You can connect either

a balanced (3 conductor TRS) or unbalanced (2

conductor TS) -equipped cable here. The input

sensitivity for the line input is located in the Setup

menu.

This jack can alternately be used as an auxilliary input

to the Mod, Delay and Reverb effects blocks in

VoiceWorksPlus. This allows VoiceWorksPlus to do

double duty as both a harmony processor for your

voice and also a multieffect for other instruments or

vocals in your mix.To use this input, the MIC IN must

be set as the main vocal input.The effects level settings

are located in the Edit menu.

3. Balanced Outputs

These are the balanced analog, line level stereo output

of VoiceDoubler.You can connect either a balanced (3

conductor TRS) or unbalanced (2 conductor TS) -

equipped cable here. You can sum the left and right

outputs to mono by changing the Output parameter in

the Setup menu.

4. Digital I/O

Sends and receives digital audio. Using digital I/O

instead of the analog I/O bypasses VoiceWorksPlus’

converter circuitry for enhanced audio clarity when

used with compatible systems.The digital output (DO)

is configured to always produce the same audio as the

main outputs.The Input parameter in the Setup menu

must be set to Digital for the digital input (DI) to

receive audio. Also, the ClockSrc must be set to

Ext(ernal) for proper audio synchronization when

using the digital input.

5. MIDI

This is the standard MIDI In, Out and Thru interface

used to allow editing, preset selection, preset dump

and restore functions.

6. Pedal

This input accepts a single function footswitch or a

triple function footswitch. Any normally-open passive

footswitch will work for the single function footswitch.

A triple function footswitch is available from TC-

Helicon called Switch 3. The switch type or volume

pedal is detected automatically on power up.If you plug

your footswitch in after power up, you may get

unexpected operation.

Footswitch (Pedal) features:

1 button footswitch: Bypass only

3 button footswitch: individually selectable in

Setup menu

1 2 3 4 65

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Tc-helicon VoiceWorks Plus Manual Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Tc-helicon VoiceWorks Plus Manual