Tc-helicon VoiceWorks Plus Manual Manuel d'utilisateur télécharger pdf (Page 9)

FRONT PANEL DESCRIPTIONS

1. Power Switch

Press to turn the unit on or off.As the unit shuts down,

it saves any setup data you may have changed.

2.Alphanumeric LED display

This 15 segment LED display shows the current preset

number whenever the EDIT and SETUP buttons are

not lit. There are dots on the bottom line indicating

whether the current preset is in the Factory or User

bank. The legend below the display indicates which dot

represents which bank. When you press the EDIT or

SETUP buttons, this display shows a letter and a

number making up the address of the current edit

screen.

3. Metering LED displays

There are several conditions indicated by these LEDs

and they are described in the following paragraphs.

Output Clip

This LED will light showing the output of the product

has clipped due to internal level overload, possibly

causing audible distortion. This LED can light even

though the Input Clip LED has not. This is because

VoiceWorksPlus has effect blocks such as Harmony for

example, that can potentially add significant level to the

input signal.

Input Clip

Steady flickering of this LED with audio input shows

that the level of the signal received at the input to

VoiceWorksPlus is too high given the input sensitivity

setting. To correct this, reduce the send level to

VoiceWorksPlus from the upstream mixer or enter the

Setup menu to reduce the LineSens (Line input

sensitivity).

Input LED Stack

These LEDs allow you to gauge how much level to

send to VoiceWorksPlus from your mixer. They use

PPM (Peak Program Meter) weighting which is a way to

view signal level when using digital processors. The

range shows logarithmic steps down from 0 dB which

is the maximum allowable level. It's important to adjust

the send level from your mixer within the proper range

shown by these meters. Sending too little audio signal

level contributes to noise buildup and unsatisfactory

performance of the voice algorithms. Too much input

signal level causes distortion. If your mixer is sending

its maximum level and these meters show insufficient

level, or vice versa, you can adjust the Input Sensitivity

setting by pressing the SETUP button and entering the

Setup menu.

MIDI IN indicator LED

This will light to confirm the MIDI data is received by

VoiceWorksPlus on the correct MIDI channel. To

ensure that it will respond correctly to the incoming

data, check to see that both your sending device and

VoiceWorksPlus are set to the same MIDI channel.

4. Main LCD display

During normal operation (none of the EDIT, SETUP or

STORE buttons are pressed), this display shows the

name of the current preset on the top line and the

main harmony or modeling parameter values on the

lower line. A slight turn of any of the soft knobs will

change the display to show master mix levels. While

the mix levels are shown, the four soft knobs allow

editing of the mix.After a few seconds the display will

revert to preset name. After the EDIT, SETUP or

STORE buttons have been pressed, this display shows

up to four editing parameters on the top line and their

associated values on the bottom. After a parameter

value has been changed, an asterisk (*) will be shown

to the left of the name when you return to normal

operation. This is to warn that you will lose any

changes should you recall another preset unless it is

saved first.

1 2 3 4

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Tc-helicon VoiceWorks Plus Manual Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Tc-helicon VoiceWorks Plus Manual