Tc-helicon VoiceWorks Plus Manual Manuel d'utilisateur télécharger pdf (Page 10)

5. Soft knobs overview

During normal operation these controls act as a mixer,

allowing you to quickly modify the global mix levels

without entering an edit menu. Moving any of the

knobs will momentarily switch the LCD display so that

it shows the levels before reverting to the preset name

and the information line.When either the EDIT, SETUP

or STORE buttons have been pressed, the soft knobs

control up to four editing functions from left to right

in the editing menus.

Global LEAD LEVEL control

This adjusts the level of the "Lead" voice. This path is

called Lead because it has no Harmony or Modeling

processing applied. Note that this path may have Pitch

Correction enabled if the Correction switch from the

upper switch group is lit.

Global HARMONY / MODEL LEVEL control

Adjusts the overall level of any harmony voices that are

turned on or the level of the modeled voice depending

on which configuration is chosen in the current preset.

Make sure the Harmony / Model switch above this

knob is lit or this control will have no effect.

Global FX LEVEL control

Adjusts the master level of the Mod , Delay, Reverb

and Transducer effects blocks for all presets. The

individual effects blocks have their own level

adjustment controls which may be turned down

preventing you hearing them when you turn the FX

Level control. Make sure the FX switch above this knob

is lit or the FX Level control will have no effect.

Global OUTPUT LEVEL control

This control raises, lowers or mutes the master output

of VoiceWorksPlus.

6. Block On/Off button group

These 3 buttons allow selective muting of blocks in

each preset to simplify editing.

HARMONY / MODEL button

When this LED is lit, the current preset is configured

to produce harmony or a modeling effect. You can

press this button to disable the current effect and see

what other effects are enabled in the preset.

CORRECTION button

This button allows you to quickly disable pitch

correction when needed.If this button is off in a preset,

turning it on will enable pitch correction with default

settings which may or may not be optimum for your

purpose. In this case you can edit the settings in the

Edit menu at location C0.

FX button

If the FX (effects) button is lit, pressing it will mute all

signal from the Mod, Delay and Reverb blocks . The

Transducer effect will not be muted. If this button is

not lit in a preset, pressing it will patch in a default

effects setting.

7. Mode Button Group

EDIT button

Press this button to enter and exit the preset Edit

menu. All settings relating to the current preset only

are accessed here. The last edit screen you accessed

with the Data Wheel is remembered to reduce time

required to locate specific edit menus.

SETUP button

Press this button to access all of the global audio

settings, MIDI functions, the EQ and Dynamics

processors and preset backup and restore. Press again

to return to recalling presets.

6 98

FRONT PANEL DESCRIPTIONS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Tc-helicon VoiceWorks Plus Manual Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Tc-helicon VoiceWorks Plus Manual