Tc-helicon VoiceLive 2 User manual Manuel d'utilisateur télécharger pdf (Page 92)

settings previously assigned to your presets but it can be

reversed later if needed.

After assigning the SHORTCUT footswitch, the Home

display will show LOOP [STOP] in any presets in which

it is assigned or all presets if LOOP is assigned globally.

Rhythmic features are disabled when Loop is assigned.

Using Looping

All looping functions are done using one footswitch.

To make a new loop:

1. Assign the SHORTCUT footswitch to looping as

discussed previously.

2.Tap SHORTCUT once on a downbeat of your music

to start recording. Sing and/or play.

3. Tap SHORTCUT again (usually on a downbeat) to

finish recording and play back your loop continuously.

The display shows [PLAY].

To overdub another layer on your loop:

1.Tap SHORTCUT once during playback. Sing.Your new

audio is added to the loop.You can layer continuously if

you like.The display shows [O-DUB].

2.Tap SHORTCUT once to stop recording and continue

playback.You can enter and exit overdubbing at any time

during playback.

To undo the previous overdub:

1. Hold SHORTCUT during overdub or playback. This

can be repeated to redo the overdub. A pop-up will

show LOOP UNDO each time.

To stop loop playback:

1.Tap SHORTCUT twice quickly during playback to stop.

This will briefly enter overdubbing so you should silence

all inputs when stopping playback.

To erase your loop:

1. Hold SHORTCUT for a moment when stopped. A

pop-up will show LOOP ERASED.This is not undo-able.

The Setup Menu:VLOOP Tab

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 104 105

Pas de commentaire

Tc-helicon VoiceLive 2 User manual Manuel d'utilisateur Page 92