Tc-helicon VoiceLive 2 User manual Manuel d'utilisateur télécharger pdf (Page 84)

DIGITAL IN

Selects between SPDIF and USB physical inputs as the

input and also specifies where the incoming digital signal

is routed. By default the routing is USB: STEREO, where

the digital input is routed to the same path as the AUX

input, but is not passed on to the digital output.

When set to USB: VOX L / INST R, or S/PDIF:VOX L /

INST R the digital input replaces the analog MIC/LINE

and GUITAR inputs and the MIC and GUITAR IN

connections are disabled.

Sample rate is synchronized automatically to the

incoming digital audio stream. There is no sample rate

adjustment in VoiceLive 2. When processing an analog

input such as the MIC and sending to VoiceLive 2’s digital

out, sending a short bit of audio from your recording

application to either Digital input will set the sample rate.

When DIGITAL IN is set to USB (or SPDIF): STEREO,

harmonies will follow the stereo audio coming from the

selected digital input on presets where NATURALPLAY

is set to AUX INPUT.

While the VoiceLive 2 is connected via USB to your

computer, other applications such as your browser may

not make sound through your regular sound card. In this

case, disconnect VoiceLive 2’s USB cable.

DIGITAL OUT

Configures the digital output between the stereo mix of

VoiceLive 2 (FULL MIX), and separated, dry outputs

used for recording (VOCAL & GUITAR).

See the section Connecting VoiceLive 2 to a Computer

for more details on recording procedures with these

digital I/O options.

LEAD MUTE

Turns the lead voice off in all presets.This is useful in the

live sound engineer setting described above or when

VoiceLive 2 is being fed by an aux send from a mixer

channel where the lead level is mixed in at the mixing

console.

LEAD DLY

When set to NONE (default), the lead voice is sent

The Setup Menu: I/O Tab

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 104 105

Pas de commentaire

Tc-helicon VoiceLive 2 User manual Manuel d'utilisateur Page 84