Tc-helicon VoiceTone Create Manual Manuel d'utilisateur télécharger pdf (Page 27)

Selecting μMod Patches

1. Turn effects on by pressing the Right Footswitch.

2. Select a μMod patch by turning the Patch Knob.

(μMod effects are located from patch 31 to 40).

3. Use the Tweak Knobs to alter the μMod effect.The

most common assignments for the Tweak Knobs are

level, feedback, depth speed.

Transducer

This is the block that helps create so many of the ear-

candy effects in popular music, as well as replicating the

vintage audio quality of older audio effects and

recordings. Within transducer there is a configurable

distortion block with internal filtering and curves, as well

as a bandwidth block, which emulates the frequency

response of various audio devices like phones and

radios.

Selecting Transducer Patches

1. Turn effects on by pressing the Right Footswitch.

2. Select a Transducer patch by turning the Patch Knob.

(Transducer effects are located from patch 41 to 50).

3. Use the Tweak Knobs to alter the Transducer effect.

The most common assignments for the Tweak Knobs

are bandwidth, pre/post gain, distortion amount, and lo

cut.

Effect & Genre Descriptions

μMod often sounds good in combination with

reverb. Therefore, many μMod patches have reverb

level assigned to a Tweak Knob so you can add that

effect.

NOTE:

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Pas de commentaire

Tc-helicon VoiceTone Create Manual Manuel d'utilisateur Page 27