Tc-helicon VoiceTone Create Manual Manuel d'utilisateur télécharger pdf (Page 36)

to listen for. Some controls are subtle like Reverb

PreDelay, Hi and Lo Colour, and Reverb Decay.

c. Try both Tweak Knobs. Sometimes, especially when

two levels are assigned, you won't hear the result of one

Tweak Knob if the other Tweak Knob is set to "0".

d. Tweak Knobs have “soft pickup”. Try turning the

knob fully leff to right, then setting the desired value.

4. Tap Tempo is not functioning properly

a. Confirm that you’ve selected a patch that has Tap

Tempo enabled by checking the Patch List, then press

and hold the Right Footswitch. If the Effect On Light

flashes rapidly once, then select another patch with Tap

Tempo enabled.

b. If the tempo is indicated by the Effect On Light

flashing in time to the music, confirm the effect is turned

on. Press and hold the Right footswitch to get out of Tap

Tempo mode. Check to make sure the Effect On Light

is on . If it’s not, push the Right Footswitch to enable it.

c. If you’ve confirmed it is a Tap Tempo patch, and the

effect is on, change Tweak X and Y controls that are

associated with Delay (Level, Feedback, Division).

5. My sound is distorted.

a. If your sound is only distorted when you have the

effect on, Check if the current patch is a Transducer

patch that has distortion enabled. Try changing Tweak X

and Y controls assigned to distortion (Distortion Type,

Distortion Level, Transducer Level, Transducer Type,

Transducer Pre/Post Gain). If distortion persists, try

turning the Input Knob to the left.

b. If your sound is distorted when the effect is off,try

turning the Input Knob to the left until the Input Light is

green and sometimes orange. If the Input Light is still

flashing red, sing further away from the microphone, or

send the mic signal through an aux send on an external

mixer.

FAQ & Troubleshooting

1 2 ... 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

Tc-helicon VoiceTone Create Manual Manuel d'utilisateur Page 36