Tc-helicon VoiceTone Create Manual Manuel d'utilisateur télécharger pdf (Page 17)

Sound Engineer Setup

If you are in a situation where a live sound engineer

mixes your vocal sound, you have the option of giving

them control over your wet/dry mix. In this

configuration the live sound engineer will have one

channel on their mixing console with your dry vocal, and

the other channel with the fully wet mono effects.They

can mix between the two to get the desired effect

balance.

Configuring Sound Engineer Setup:

1. Connect your microphone to Create's Mic Input.

2. Connect to your sound system as indicated: Left

and Right Outputs to two mic inputs on your sound

system. Set your sound system’s pan pots to center.

3. Connect Create's power adapter to main power

and to the Power Input on Create.

4. Confirm that stereo mode is off. If the Stereo Light

is on, press and hold Performance Buttons 4 and 5

simultaneously until the Stereo Light turns off.

5. Turn the Mix Knob fully right. In this configuration,

the sound engineer will have access to your dry voice on

the Right Output, and your fully effected voice on the

Left Output.

Setup Configurations

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Pas de commentaire

Tc-helicon VoiceTone Create Manual Manuel d'utilisateur Page 17