Tc-helicon VoiceTone R1 Manual Manuel d'utilisateur télécharger pdf (Page 7)

First Setup and Use

1.TurndownyourPA’smastervolume.

2.ConnectyourmicandPAasshowninthediagramfirst,thenplugintheACadaptor.Forlive

performance,aUSBconnectiontoacomputerisnotrequired.

3. Set the Reverb style to Hall and the mix control to the center notch.

4.SingintoyourmicwhileadjustingtheMICGAINcontrolsothattheinputlevelLEDflashesgreen.

BriefflashesofredontheLEDonyourloudestsingingareok.

5.Ensurethattheeffectison(centerLEDislit).

6.SingwhileturningupyourPAvolumetoacomfortablelevel.

You can now sing while you sample the different reverb styles and raise and lower the mix. You’re

ready to perform!

Phantom Power

ThereisnoswitchtoenablephantompowerontheVoiceTonesingles.Phantompowerisavailable

when the product is powered. Microphones that don’t require phantom power will operate properly.

AlwaysapplypowerasthelastconnectionstepandensureyourPAismuted.Thiswillreducethe

chance of audio pops that could harm your equipment.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Tc-helicon VoiceTone R1 Manual Manuel d'utilisateur Page 7