Tc-helicon VoiceLive Touch 2 Quick Guide Manuel d'utilisateur Page 1

Quick GuideStoreINPUTHomeHold for GenreEffectsVoicesTapMixSetupLoopHitHold for Ta lkEdit

7Effects, Voices and basic editingNote that Harmony requires a musical reference from either:a) guitar chords from a guitar connected to the Guitar I

8With acoustic instruments – using RoomsenseThe VoiceLive Touch 2’s Roomsense mics can pick up chords from a nearby acoustic instrument and use them

9adVanced loop function tutorial• Tap the Loop button once or twice to display the loop functions menu (Erase, Clear etc).• Tap the Matrix button as

10slider fX bar effectsUsing the Slider FX Bar effectsIn Effects and Loop modes, the Slider FX Bar can be used to control an effect. The name of the e

11Guitar effects & optional accessoriesoptional accessoriesYou can control VoiceLive Touch 2 remotely using the following op-tional accessories:•

12troubleshootinG“Where can I find support for this product?”Point your web browser to www.tc-helicon.com/support.“Why am I hearing feedback?”Move you

13“I can’t see any INPUT indication when I sing into my mic.”Make sure that…• the INPUT setting in the Setup menu is set to CONDENSER MIC if you need

14SpecificationsMIDI: In 5 Pin DINPedal: 1/4” TRS phone jackPowerExternal Power Supply: 100 to 240 VAC, 50 to 60 Hz (auto-select)Power Consumption: &

CautionYou are cautioned that any change or modifications not expressly ap-proved in this manual could void your warranty.eMc/eMiThis equipment has be

Table of contentstable of contentsMounting to a mic stand ...1The VoiceSupport application ...

1MountinG to a Mic standMic stand setup1. With no cables attached to the product, grasp it on both sides so the printed top faces you and is approxi

2startup• Connect the AC adaptor and apply power to the unit.• Turn the Mic Gain control fully left.• Connect a Microphone to the Mic In jack.• Co

35. Guitar Input and Thru: Connect your guitar to the high Z (im-pedance) In jack directly using a 1/4” cable. If you use effect pedals, these pedals

4usinG the front panel buttonsAll buttons require only a soft tap to engage.Tap the mode buttons (Edit, Store, Effects, Voices, Setup, Mix, Loop) to d

5usinG the slider fX barUsing the Slider FX Bar: swipingA quick flick along the Slider FX Bar (13) will start it freewheeling through the parameter va

6selectinG and auditioninG presetsEnsure the Home button is lit. Home is the main operational mode. You can always press the Home button (3) to exit a