Tc-helicon VoiceTone Synth Manual Manuel d'utilisateur télécharger pdf (Page 27)

I can’t hear any audio coming out of the

product

o Confirm you have power and a working mic by

singing through the mic and confirming that Input

LED flashes green, and sometimes orange.

o If Vocoder is turned on and set to Inst, there must

be audio coming from your instrument at the same

time you are vocalizing through the product.

o Confirm the Mono Out is connected to a PA.

I hear distortion

o Check the input LED, if it is flashing red, then turn

down the input volume.

o Is Transducer enabled? If so, the distortion may be

part of that style.

I can’t hear any effect

o Make sure the On LED is lit.

o Ensure that at least one of the three effects is

activate.

o If Vocoder is turned on, and Inst is selected, make

sure there is audio coming from you instrument.

Try turning up your instrument level if the problem

persists.

The effects sound out-of-tune

o Try using a fixed key and scale.

o Make sure your instrument/tracks are tuned to

A440.

o If you’re using Auto mode, turn up the level of the

instrument/source.

I’m using a Distortion style, but can’t hear it

o Raise your input level so the Input LED is flashing

orange.

My Instrument doesn’t seem to change the key

of the effects

o Confirm Auto key and scale is selected.

o Confirm Vocoder with a Synth sound is selected, or

HardTune is on.

o Remove any guitar effect pedals between your

FAQ and Troubleshooting

1 2 ... 22 23 24 25 26 27 28 29 30 31

Pas de commentaire

Tc-helicon VoiceTone Synth Manual Manuel d'utilisateur Page 27